With the refinement of industrial electronics, the requirements for stamping parts are getting higher and higher in various industries, including the shape of stamping parts. In the blanking process of stamping parts, the phenomenon of turning and twisting is simple, which affects the quality of the products. The technicians of Kunshan Kunzhun Electronic Technology Co., Ltd. share with us: the processing method of metal stamping parts turning and twisting.
　　 The metal stamping parts are turned over and twisted, and the blanks are generated when punching. It is necessary to study the cutting edge and pay attention to see if the blanking clearance is reasonable. At the time of punching, the turning and twisting deformation of the punching piece has occurred, resulting in poor forming after bending, and it is necessary to start the processing from the blanking work station.
　　 Caused by the instability of the stampings during bending. Primarily for U-shaped and V-shaped bends. The treatment of this problem, the guiding position before the bending of the stamping, the guiding position during the bending process, and the pressing of the data during the bending process to prevent the stamping from slipping during the bending are the main points of the processing problem.
　　 We are now aware of the trust in the handling of metal stamping parts. The most important reason for the turning of the stamping parts is the influence of the punching force and the unreasonable blanking gap and the unevenness of the gap. After the above methods, these problems can be effectively treated to prevent the stamping parts from being turned and twisted.
　　 A good metal stamping section should first control the burr, minimize the burr, and secondly pursue the bright belt. Many of the more demanding metal stamping parts, the customer will propose the proportion of the bright belt in the entire section, of course, this is the scope of precision stamping.